XPost: alt.checkmate, alt.transgendered, alt.flame   
   XPost: alt.slack   
   From: f00@0f0.00f   
      
   ðŸŒˆðŸ’�🌻🌺🌹🌻ðŸ’�🌷🌺🌈 Jen 🌈ðŸ’�🌻🌺🌠  
   ðŸŒ»ðŸ’�🌷🌺🌈 D ershmenderde   
   nden...den-den *jazz hands*   
   ðŸ’�🌻🌺🌹🌻ðŸ’�🌷🌺ðŸ�¶ç¬›ðŸŒˆðŸ’�🌻🌺🌹🌻𠠠
   ’�🌷🌺🌈 wrote:   
   > ...just for the extra stocks.   
   >   
   > i devised a minimal-waste plan where only five 2" diameter circular plugs   
   > are "kerf" aside from the coping saw cuts.   
   >   
   > ...which involved a good 20 minutes of using the coping saw to cut out   
   > the side parts.  I had to take breaks, so that ended up taking about an   
   > hour.  Ripping the cross-members made a lot of dust so I had to take   
   > breaks and let the dust settle so that my smoke alarm didn't start going   
   > crazy.   
   >   
   > The cross-members were recycled from an old table that I had used in the   
   > workshop.  It was an Ikea cardboard type table and I used this wood for   
   > the interface with the leg system that I had made out of 2" ABS pipe.   
   >   
   > I also re-purposed all of the screws into the gun rack.   
   >   
   >  original topological plan   
   >  the side boards being hole-sawed   
   >  this is how I cope...   
   >  sides separated   
   >  testing if a rifle + scope will fit   
   >   
   > (no AI is ever involved in my mistakes, btw)   
   >   
      
   are you planning on opening a gun meuseum?   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)