From: wlobb@hvc.rr.com   
      
   Hi All,   
      
   I have been using FVS318 v1 and v2 routers for a while for VPN tunnels   
   between client sites and they work great, as does the SafeNet 10 software. I   
   cannot for the life of me get FVS318v3 to FVS318v1 tunnel to connect. I have   
   tried to update the firmware, used FQDN and IP addresses, I notice that the   
   v1 and v2 don't seem to use authentication and the v 3 seems to require it.   
   I wish Netgear had never changed the interface or come up with the "Wizard".   
   I could set up two of the old routers with a tunnel in about ½ an hour. I   
   have been beating on this thing for a week. I have even replaced routers. Is   
   there a comprehensive document that discusses the settings between FVS318v3   
   and FVS318v1? I am at a loss.   
      
      
      
   Thanks,   
      
      
      
   Bill Lobb   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)