From: icc85@hotmail.com   
      
   My first guess would be that you don't have IPsec forwared to your   
   Shitguard.   
   BTW the Draytek routers as far as I know are the only ones out there that   
   support PPPoA.   
   I would check you dray config again and click IPsec there that the show, and   
   then go to forwarding   
   and make sure you have it forwading on to you Sguard.  But also not that   
   most if not all   
   of these SOHO routers simply don't route VPN traffic beyond the front end   
   device.   
   Is there any reason you need to use PPPoA?   
      
   icc   
      
   "Mark Anyon"  wrote in message   
   news:fa608253.0311270328.6f6b9d74@posting.google.com...   
   > Hi, I have three sites connected to internet via pppoA adsl.   
   > I am using draytek 2600 vigor routers, but behind each of those is a   
   > watchguard soho 6tc which i need to connect all three via vpn.   
   > The external interface on the watchguard does not have a pppoA client   
   > much to my disapointment!   
   > I need to configure the draytek to pass thru ipsec traffic to the   
   > watchguard.   
   > I have followed the instructions on draytek support site:   
   >   
   > http://www.draytek.com.tw/application/vpn_solution_1_b_ipsec.php   
   >   
   >   
   > But still no luck.   
   > Watchguard have remoted into my sohos and said the vpn config is fine   
   > but i should be using a public ip on the external interface.   
   >   
   > Any help greatly appreciated!!   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)