From: ohland@charter.net   
      
   Page 117 [Finish the fight! ]   
      
   Installing the Auxiliary Power Supply   
      
   Follow these instructions for installing the auxiliary power supply   
   1. Check the adapter to make sure that the plastic jumper blocks are set   
   as follows:   
      
   1055 adapter: Remove jumper blocks from pins of jumpers W3   
   and W4   
      
   Louis Ohland wrote:   
   > Page 111   
   >   
   > Jumper Positions for the 1055 Adapter   
   > W1 - W2 (Disk/Tape selection): These jumpers should always be set toward   
   > the middle of the board (the disk position).   
   >   
   > W3 - W4 (+5V & + 12V): These power jumpers are normally jumpered to   
   > allow + 5V and + 12V to power the external floppy drives or tape drive   
   > from the internal power supply of the computer.   
   >   
   > It is possible that you may need to have other cards plugged into the   
   > system that excessively load down the internal power supply. In this   
   > case, these jumpers should be removed and a SYSGEN external power supply   
   > can be used to power the external drives.   
   >   
   > Louis Ohland wrote:   
   >> https://www.minuszerodegrees.net/manuals/Sysgen/Sysgen%20Brid   
   e-File%20-%20Owner's%20Manual%20-%20Revision%20F.pdf   
   >>   
   >>   
   >> Covers 1055 as well.   
   >>   
   >> Louis Ohland wrote:   
   >>> https://www.ebay.com/itm/116557128971   
   >>>   
   >>> BIN / MAO   
      
   --- SoupGate-DOS v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)