From: crwlr@verizon.net   
      
   Why do you mess around with a stone axe and hammer when working on your   
   truck?   
      
   AutoZone will pull the codes free of charge using a scan tool tha tis   
   specifically meant for the job. The scan tool will reset the codes for you   
   too. You do not have to unplug the battery, then deal with programming the   
   radio again.   
      
   Pull the codes with the scan tool, and know that you are actually woriking   
   on the right stuff. You can leave the gas cap loose and get a Check Engine   
   light as a result.   
      
      
      
      
      
   "Brad P"  wrote in message   
   news:g40l87$irh$1@news.datemas.de...   
   >I have an 03 XtraCab Tacoma with 70,000+kms on it. The Air Fuel Mixture   
   >sensor died recently which made the CEL light up, so I bought a new one off   
   >ebay. It is a Denso brand which is apparently the brand used by Toyota.   
   >When I had the code read prior, the CEL no longer appeared.   
   >   
   > So once the new sensor was installed, the CEL remained off which was great   
   > but after 300kms it came on again. Just for kicks, I disconnected the   
   > battery to reset it and reconnected. The light has remained off now for   
   > about 50kms. My question is would a problem still exist despite the CEL   
   > not displaying as a result of the reset I did? or is it safe to assume   
   > there isn't a problem currently.   
   >   
   > Thanks   
   >   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)