From: giannotti.lorenzo@gmail.com   
      
   ahh, right, I finally discovered the contacts on the most left of the   
   reversing switch seem to be shorted. From the manual I see this should be the   
   cancel solenoid ones...   
   ok, found it opening the top back door, there are two of them.   
   Now, it seems quite difficult to access them and see what happened without   
   taking out the Whole motor block.   
   Any clues to unblock the solenoids (maybe for some reason stuck) or should I   
   start to take out the motor block?   
      
   Thanks a lot again   
       
      
   Il giorno venerdì 23 marzo 2018 15:44:22 UTC+1, Mike Thomas ha scritto:   
   > Probably bent contacts on reversing switch.   
   >    
   > Mike   
   > On Fri, 23 Mar 2018 00:32:04 -0700 (PDT), Lore   
   >  wrote:   
   >    
   > >Hi,   
   > >I had to dismantle my working 100r in order to restore the cabinet.   
   > >I have been quite careful but after puttting it togheter motor is dead.   
   > >Ok, 3A fuse blown.   
   > >Replaced, blown again...   
   > >Now I have to trace the problem. I have the service manual but before   
   starting, any ideas of what is more probably the problem?   
   > >   
   > >Thanks   
   > >Lore   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)