Hello.   
      
   I have a Rowe CD100C that I've managed to make very nice... but I'm having a   
   bit of trouble with the Title rack keyboard interface. The pages started   
   randomly turning, then went out completely.   
      
   I pulled the title rack interface board (assembly 40856101) to find a burnt   
   component on the BACK side of the 40853001 board. It was so burnt (snapped in   
   half and looked like charcoal) I couldn't be 100% sure what it was... but it   
   appeared to be a    
   resistor going from pin 7 of the P6 connector to pin 1 of the U2 chip.   
      
   I found this thread: https://groups.google.com/d/topic/alt.colle   
   ting.juke-boxes/8p6qZBWYnqI/discussion   
      
   I put a 25 ohm cement resistor there (closest I had) and it worked! For a   
   week... found a 15 ohm 1/2 w carbon film resistor, and it worked! For about 10   
   minutes then smoked out. The 15 ohm 1/2 w metal film resistors seem to be   
   pretty hard to find.   
      
   Maybe I'm barking up the wrong tree? The board I have (Rev A) ends at R14 and   
   doesn't have the R15 or 16 mentioned. It appeared they cut the trace for that   
   circuit at the factory and added the part to the back... didn't look to be   
   hacked in by someone    
   else anyway.   
      
   Any suggestions? All help would be greatly appreciated.   
      
   Thanks!   
      
   Charlie   
   http://www.spookypinball.com   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)