From: earlcp@idirect.com   
      
   Michael Koenig  :   
      
   > Steve Wilson wrote:   
   > > IDE ATAPI -- request_sense: logical block address out of range   
   > > IDE ATAPI -- send_packet: command 0xa0 failed, status 0x51 error 0x00   
   > > with error Device seek error   
   > > IDE ATAPI -- readsector: disk/ide/atapi/0/slave/0/raw giving up read/   
   > > write(12)   
   >   
   > Strange, are you sure that your CD-ROM drive is OK?   
   >   
   > > System:   
   > > Pentium 2 350Mhz   
   > > 327MB RAM   
   > > Asus P2B Motherboard   
   >   
   > Shouldn't be this hardware because I ran BeOS R5 Professional on exactly   
   > the same hardware (although only 256MB RAM) until I upgraded to a 550MHz   
   P3.   
   >   
   > > Hardrives are SCSI on ultra-wide adaptec controller   
   >   
   > What SCSI controller is that? BeOS R5 only supports a small selection,   
   > and it doesn't seem that anybody has written any additional SCSI drivers   
   > since. Take a look here to see what controllers and chipsets are supported:   
   >    
      
   What are the odds that the IDE driver on bebits would help?   
      
               Earl Colby Pottinger   
      
      
   --   
   I make public email sent to me!  Hydrogen Peroxide Rockets, OpenBeos,   
   SerialTransfer 3.0, RAMDISK, BoatBuilding, DIY TabletPC.  What happened to   
   the time? http://webhome.idirect.com/~earlcp   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)