From: unruh@invalid.ca   
      
   On 2012-11-16, Adam  wrote:   
   > TJ wrote:   
   >> Shoulda learned how to run it from the command line instead of doing it   
   >> through MCC. Probably would have had some feedback that way.   
   >   
   > I'd say cancel MCC and start again with 'mke2fs' for each partition from   
   > the command line.  My usual is "mke2fs -ccjv -t ext4 /dev/sd??" but read   
   > the man page first.  You may want to use -m as mentioned in this thread.   
   >   Note -c is used twice for a read/write test.  With -v, it will keep   
   > you informed of its progress.  Over 30 hours sounds quite within reason   
   > for a ~1 TB partition.   
      
   Write 1TB of data at 100MB/s say is about 3 hours. Ie, it should not be   
   taking 30 hours. (reading should be a bit faster, and the comparison   
   should be instantaneos) Unless the mke2fs is writing one byte, then   
   reading it back and comparing it (which would be lunacy)   
      
      
   >   
   > Adam   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)