> you haven't said what bbs software it is for but i cannot imagine that no 
 > one else would want to use it...

 RT> I use now on this moment EleBBS, 

Ele is a RA clone ;)

 RT> but i found that there is a bug with the  telnet connection and 
 RT> the door.sys or dorinfo.def when a user connects with  the 
 RT> internal telnet server from EleBBS then i give a connection of 
 RT> 6550 baud  in the door.sys or dorinfo.def

that is not a valid baud rate... is this using a FOSSIL or no?

FWIW: the valid baud rates are...

    110, 300, 600, 1200, 2400, 4800, 9600, 14400, 
    19200, 28800, 38400, 56000, 57600, 115200

some serial ports support these higher rates

    128000, 153600, 230400, 256000, 460800, 921600

but they are no valid for our old school BBS operations... in fact, locking a
serial port to 115200 in one FOSSIL driver requires one to use 11520 because
the baud rate speed value is stored in a word (0..65535)...

you should not "float" your serial connection... you should run it with a
"locked" port rate and then let the (virtual) modem handle the actual connect
rate with the remote on its own while talking to the local "port" at one
specific rate...

 RT> and there are some doors that then not work,  becoss the not 
 RT> correct baud rate it give out in the door file. 

i don't doubt they won't work with an invalid baud rate like that...

 RT> I had a official key for the QWK mail door of coder from Wildcat
 RT> BBS and try  to install it and it works but not with that baud
 RT> rate, and the only door that  i found then was that from Cutting
 RT> Edge...

that's weird... unless there's a locked port rate setting...

 RT> But it is oke i will be use it unregistered, i dont have many user
 RT> that will  use the QWK Mail door it is just that i support it on
 RT> the BBS ;) 

ok...

)\/(ark

 * Origin:  (1:3634/12)