Hello,   
      
   We have a Cisco 2901 with multiple WICs and three of the Routing Interfaces   
   are connected to the same single dumb switch.     
      
   Obviously the interfaces should not normally be connecting to the same switch,   
   but that's how our system is currently designed.     
      
   The odd thing is when a Windows PC (no IP yet) and another device (device   
   A,for example IP 10.10.10.1) are both connected to this same dumb switch, when   
   we try to configure an IP on the Windows PC, the PC responds with IP address   
   conflict. We are sure    
   there is no IP conflict, but the message comes up everytime.   
      
   Even though we can try any random IP on the Windows PC, it always responds   
   with IP conflict.     
      
   If I remove the three network cables from the router interfaces, with just the   
   Windows PC and device A connected, I can configure the Windows PC IP with no   
   problem and communicate with device A. Ever after putting the cables back into   
   the router,    
   everything seems fine at that point.   
      
   So the problem seems to only appear when trying to set an IP on the PC, but   
   once the IP is set, all seems well.  I'm certain it's not related to a true IP   
   conflict, but maybe something in the way Windows detects IP conflicts?     
      
   Maybe PC having the same MAC address across multiple interfaces causes this????   
      
   Does anyone know why the PC would think there is an IP conflict when trying to   
   set the IP?     
      
   Very curious...   
      
   Thanks in advance!   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)