From: tthompson1314@gmail.com   
      
   On Sunday, April 3, 2022 at 10:08:10 PM UTC-7, Bob Darlington wrote:   
   > On Tuesday, September 18, 2018 at 7:59:01 AM UTC-6, a2retro wrote:    
   > > Just an FYI : I happen to be looking at teh Apple IIgs #28    
   > > Interface Card Design Guidelines and noticed the dimensions of the   
   standard 50 pin slot connector are wrong.    
   > >    
   > > They are listed as 2.95 inches when it should be 2.59 inches   
   > I confirm the technical docs are WRONG. 2.590" to 2.600" seems fine. My   
   Mockingboard is 2.600 (or was it the Uthernet?).    
   >    
   > -Bob   
      
   The dimension is right, the arrows are wrong...  Or the ASCII art is poor. The   
   2.95" dimension is from the "front" of the edge connector to the rear of the   
   entire board, I saw a poor/cut off PDF scan that made it clearer. The   
   dimensions are from a common    
   origin, as is correct practice, and it is formed by the intersection of the   
   rear most edge of the board and the very bottom of the edge connector  - a   
   location that is in open space due to the outline of the board.   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)