home bbs files messages ]

Forums before death by AOL, social media and spammers... "We can't have nice things"

   comp.sys.raspberry-pi      Raspberry Pi computers & related hardwar      26,127 messages   

[   << oldest   |   < older   |   list   |   newer >   |   newest >>   ]

   Message 25,962 of 26,127   
   Jim Diamond to Richard Kettlewell   
   Re: RPi associating two IPs with its one   
   31 Dec 25 16:09:37   
   
   From: zsd@jdvb.ca   
      
   On 2025-12-31 at 09:15 AST, Richard Kettlewell  wrote:   
   > druck  writes:   
   >> On 30/12/2025 01:00, Jim Diamond wrote:   
   >>> However, it was worth a look.  Maybe.  According to the router, the   
   >>> "mystery" address is paired with the wifi card's actual ethernet (MAC)   
   >>   
   >> MAC's aren't just Ethernet, WiFi and Bluetooth interfaces also have them.   
   >>   
   >>> address, whereas the "proper" address is (currently) paired with the   
   >>> same ethernet address, except the last octet is 8C instead of 8D.   
   >>> This makes me think that it is showing "Connected" or "Disconnected"   
   >>> according to the ethernet address which is working, and it is not   
   >>> careful about pairing that with the correct IPv4 address.   
   >>   
   >> You often see a difference of 1 when something creates a virtual   
   >> network interface for use by a virtual machine or container. The   
   >> virtual network card is assigned the second IP address and can operate   
   >> independently from anything using the hosts primary interface and IP   
   >> address.   
   >   
   > At least on my 3B and 4B, the wired and wireless interfaces have   
   > adjacent MACs.   
   >   
   >     PS C:\Users\rjk> ssh shairo ip link show   
   >     1: lo:  mtu 65536 qdisc noqueue state UNKNOWN mode   
   DEFAULT group default qlen 1000   
   >         link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00   
   >     2: eth0:  mtu 1500 qdisc noop state DOWN mode   
   DEFAULT group default qlen 1000   
   >         link/ether dc:a6:32:cb:73:6b brd ff:ff:ff:ff:ff:ff   
   >     3: wlan0:  mtu 1500 qdisc fq_codel   
   state UP mode DORMANT group default qlen 1000   
   >         link/ether dc:a6:32:cb:73:6c brd ff:ff:ff:ff:ff:ff   
   >   
   > If both interfaces were connected to the same network then I might see   
   > something similar to Jim’s situation.   
   >   
   > I did ask Jim for ‘ip addr show’ output but it has not appeared.   
      
   Mea culpa, I thought I did.   
      
   Here is today's output... but I have long since gotten rid of that extra   
   IP, so I'm not sure if this is at all interesting:   
      
   1: lo:  mtu 65536 qdisc noqueue state UNKNOWN group   
   default qlen 1000   
       link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00   
       inet 127.0.0.1/8 scope host lo   
          valid_lft forever preferred_lft forever   
       inet6 ::1/128 scope host noprefixroute   
          valid_lft forever preferred_lft forever   
   2: eth0:  mtu 1500 qdisc mq state DOWN   
   group default qlen 1000   
       link/ether dc:a6:32:37:93:8c brd ff:ff:ff:ff:ff:ff   
   3: wlan0:  mtu 1500 qdisc pfifo_fast state UP   
   group default qlen 1000   
       link/ether dc:a6:32:37:93:8d brd ff:ff:ff:ff:ff:ff   
       inet 192.168.2.74/24 brd 192.168.2.255 scope global noprefixroute wlan0   
          valid_lft forever preferred_lft forever   
       inet6 fe80::d10a:4386:b7f7:43f9/64 scope link noprefixroute   
          valid_lft forever preferred_lft forever   
      
   Should it happen again I'll capture this output in case it helps find the   
   source.   
      
                                   Jim   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)   

[   << oldest   |   < older   |   list   |   newer >   |   newest >>   ]


(c) 1994,  bbs@darkrealms.ca