MSGID: 2:250/1@fidonet 61fdb510
CHRS: UTF-8 2
TZUTC: 0000
TID: MBSE-FIDO 1.0.7.24 (GNU/Linux-x86_64)
Hello All!

I want to run a second version of mbse on a Raspberry Pi with a USB connected
1Tb Sata HDD as a back up system but more likely to just run the elist
software.  This way I can having set it up pass on the elist batton to some 
one
else as a total system as all it needs is LAN cable to router or hub, HDMI
cable for a monitor and if needed a two wire power cable (using a 8 socket)
for power.  Now it can work any where in the world as the power adaptor is one
for a Laptop with a voltage range of 100 - 240.
The benefit of this is that it is very low power requirement although it 
should
be connected to a UPS if at all possible (and yes my kit does even if only
good for around a hour).

Now as the primary BBS uses the standard port 24554 I would like it to use
24555.

This way I can tell the Router to port forward 24554 to pass all traffic to 
the
primary and if a poll comes in using 24555 to pass traffic to the Pi.

I cannot see how you set up the port in mbse and I think I have looked every
where (unless some one knows otherwise by doing a search of the manual for
'24554')  as it looks like 24554 is the standard and can't be changed - or can
it ?





Vincent

--- Mageia Linux v8 X64/Mbse v1.0.7.24/GoldED+/LNX 1.1.5-b20180707
 * Origin: Air Applewood, The Linux Gateway to the UK & Eire (2:250/1)
SEEN-BY: 1/120 123 15/0 18/0 200 25/0 21 90/1 105/81 106/201 120/340
SEEN-BY: 123/0 25 131 180 200 755 129/305 330 331 135/300 138/146
SEEN-BY: 153/7715 154/10 222/2 226/30 227/114 229/110 206 317 400
SEEN-BY: 229/424 426 428 452 550 664 700 240/1120 5832 250/0 1 2 3
SEEN-BY: 250/4 5 6 7 8 10 21 263/0 266/512 275/100 1000 282/1038 292/854
SEEN-BY: 299/6 301/1 317/3 320/219 322/757 342/11 200 396/45 460/58
SEEN-BY: 633/280 640/1321 712/848 3634/0 12 15 27 50 119 5020/1042
PATH: 250/1 3634/12 153/7715 229/426