INTL 3:770/1 3:770/3
REPLYADDR address@is.invalid
REPLYTO 3:770/3.0 UUCP
MSGID:  951731f0
REPLY:  a83d6c09
PID: SoupGate-Win32 v1.05
Adrian,

> ... the options seem to fall into two categories, either a relay device
> which means having to rewire the device (which I'd rather avoid), priced
> around 30Euros or one that sits in line (between the device and the
> supply)

Whut ?   As others have already mentioned, you could take a short extension
cord and put the relais* in that cord.  Makes it reusable too.

* also consider a solid-state relais.

Also, you say USB controlled.  How do you imagine that ?  As some kind of
special USB device (for which it is hard to find a driver) ?

Perhaps consider a simple USB-to-serial thingly*, where you can use the DTR
line to signal the relais board to switch on.  After that you can use the
RPi build-in serial API to switch the relais.

* I would strongly suggest to use one of RPi's gazillion I/O pins for it,
but as you specifically mentioned USB controlled ...

The only thing you will need to do (and which costs money) is to put the
relais (and the USB-to-signal-line thingamagochy ?) in a shielding plastic
box.  220 is lethal even when you touch it by accident. :-)   And make sure
the 220v and the relais-driving low-voltage electronics are well seperated.
Your RPi doesn't like 220v either. :-o

Regards,
Rudy Wieser

--- SoupGate-Win32 v1.05
 * Origin: Agency HUB, Dunedin - New Zealand | Fido<>Usenet Gateway (3:770/3)
SEEN-BY: 19/38 105/81 106/201 128/187 129/305 153/757 7715 154/110
SEEN-BY: 218/700 840 220/70 226/17 30 100 227/114 229/110 111 114
SEEN-BY: 229/200 206 300 317 400 426 428 470 550 616 664 700 705 266/512
SEEN-BY: 267/800 291/111 292/854 310/31 320/219 322/757 342/200 396/45
SEEN-BY: 460/58 633/280 281 418 420 509 2744 712/848 770/1 3 100 330
SEEN-BY: 770/340 772/210 220 230 902/26 2320/105 5020/400 5075/35
PATH: 770/3 1 633/280 229/426