From: none@none.com99   
      
   On 7/13/2024 11:31 AM, Bob La Londe wrote:   
   > Geometric Self Opening Die Heads   
      
      
      
   >   
   >   
   > If you don't want to watch the whole video here is where he runs through   
   > one part.   
   > https://youtu.be/WXoG9uEMIpA?si=eZCT38b5dpSwocNM&t=1141   
   >   
   > I am sure if I look around I can find a used version of this tool for   
   > less than a brand new one, but I need to ask. Have you used a tool like   
   > this.  The self opening die head, not a turret lathe.  I am sure lots of   
   > you have used a turret lathe.  How easy was it to setup for each job?   
   > How affordable where the thread jaws?  Did you find it worked reliably?   
   > Do you have nay other feedback for using one or reasons not to?   
   >   
      
   Another groups take on the subject:   
   https://bbs.homeshopmachinist.net/forum/general/2095061-geometri   
   -self-opening-die-heads#post2095515   
      
   After reading all the comments I have concluded that geoseismic button   
   taps are bad for single point reaming.   
      
      
      
   --   
   Bob La Londe   
   CNC Molds N Stuff   
      
      
   --   
   This email has been checked for viruses by AVG antivirus software.   
   www.avg.com   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)