From: djb@invalid.com   
      
   On 06/09/2024 20:44, Snag wrote:   
   > This time the Big Score is a 3 inch 3 jaw chuck on a 5c collet back   
   > plate with 3 sets of jaw (all fit) for the princely sum of 10 bucks .   
   > A piece of material for a 1 1/2-8 back plate will probably cost more   
   > than the chuck . Also got a couple of open/reversible ratchet shorty   
   > wrenches for a buck each .   
      
   I bought one of those and it has proved fairly handy but I found as   
   supplied it had quite a bit of run-out and the chuck wasn't square. I   
   separated the chuck from the 5C backplate and found that was badly   
   machined but once correctly machined it now runs quite true for a cheap   
   chuck.   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)