From: muratlanne@gmail.com   
      
   "David Billington"  wrote in message news:vbfvlm$vmm4$1@dont-email.me...   
      
   On 06/09/2024 20:44, Snag wrote:   
   > This time the Big Score is a 3 inch 3 jaw chuck on a 5c collet back plate   
   > with 3 sets of jaw (all fit) for the princely sum of 10 bucks . A piece of   
   > material for a 1 1/2-8 back plate will probably cost more than the chuck .   
   > Also got a couple of open/reversible ratchet shorty wrenches for a buck   
   > each .   
      
   I bought one of those and it has proved fairly handy but I found as   
   supplied it had quite a bit of run-out and the chuck wasn't square. I   
   separated the chuck from the 5C backplate and found that was badly   
   machined but once correctly machined it now runs quite true for a cheap   
   chuck.   
      
   -------------------------------------   
      
   I have one as well, in a wooden box, likely from Enco. It's not my first   
   choice on the lathe but it's very handy for machining indexed wrench flats   
   etc on turned parts. A chuck small enough to pass over the carriage allows   
   facing both sides of gear or pulley blanks held by the hole ID, and (like   
   collets) bringing the tailstock close to the chuck for accurate center   
   drilling.   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)