From: Snag_one@msn.com   
      
   On 6/8/2025 5:05 PM, Clare Snyder wrote:   
   > On Sun, 8 Jun 2025 16:04:09 -0500, Snag  wrote:   
   >   
   >>    I managed to lose one of the pins that hold the lift link clevis to   
   >> the lower arms on my "new" tractor - adjustment turnbuckle was froze up   
   >>from several years sitting out in the woods . I made one from some   
   >> mystery steel I have on hand but I got to wondering if I should have   
   >> used some of the 4140 I have on hand or maybe case hardened it . The   
   >> 4140 is larger diameter , so more waste . I hate wasting material if I   
   >> don't have to . For all I know the piece I used is alloy , but it isn't   
   >> marked . I usually mark bought material but found or gifted stock I   
   >> don't always know what I've got so ...   
   >   I use grade 5 or grade 8 bolts as feed stock, depending on required   
   > strength and hardness. - or even grade 3 if that is all that is   
   > required. I go by the head markings to know what I have - - -   
   >   
      
      This didn't start out as a bolt , it's from  a 1" piece of round   
   stock. Bolts are way too expensive to use as lathe stock .   
   --   
   Snag   
   We live in a time where intelligent people   
   are being silenced so that   
   stupid people won't be offended.   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)