From: muratlanne@gmail.com   
      
   "Snag"  wrote in message news:104fbh2$qhc0$1@dont-email.me...   
      
     The PTO clutch on my old JD 317 died recently , and today I got around   
   to figuring out why . The rivets that hold the clutch disk to the pulley   
   assembly had vanished ! Wore plumb off down to nubbins is more like it .   
   So I jumped on the interwebs to see what it would cost to replace ...   
   and there ain't no way in hell I'm going to drop 250 bucks for this part .   
      So I got to inspecting and figured out that I could machine some   
   rivets from a piece of hot rolled 1/2 inch mild steel . And it worked .   
   ...   
   Snag   
      
   -----------------------------------------   
      
   I think my machine tools and welders have saved several times their purchase   
   price on things I could repair or build from scratch instead of buying. It's   
   hard to add up because the sawmill to salvage straight oak trunks and bucket   
   loader to clear snow were helpful but not essential and I could have limited   
   myself to electronics at work instead of adding machining. Some of the   
   shop-made parts that salvaged free/cheap old outdoor equipment might have   
   been found at the cost of time and gasoline. The rebuilt garden tractor and   
   log splitter enabled free wood heat, a big but unknown savings. MIG welding   
   has kept the vehicles registered, I machined custom tools for them but not   
   automotive parts which are often heat treated and plated. Antenna instead of   
   cable TV saved a big bundle, the machined repair parts for antenna storm   
   damage should count against antenna replacement rather than the whole   
   system. The elements aren't tubing, they were rolled from flat stock which I   
   have copied with hand tools. When they hit the roof they break without   
   damaging the shingles.   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)