From: muratlanne@gmail.com   
      
   "Bob La Londe"  wrote in message news:10k62v8$6jli$2@dont-email.me...   
      
   On 1/13/2026 11:28 AM, Bob La Londe wrote:   
   > A t-joint wheel is going to be quite rigid.  Cut a round ring for the   
   > bottom leg of the T.  Ring roll the blade surface of the wheel.  Add   
   > spokes from your ring to your hub.   
      
   Or just cut sections to save materials and weld them in between the   
   spokes.   
   Bob La Londe   
      
   -------------------------------   
   That would push my amateur skill further than I dare for a heavy wheel   
   spinning up to 60MPH rim speed 3' from me.   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)