From: wolverine01@charter.net   
      
   On 9/23/2024 9:22 PM, sticks wrote:   
   > Well I spent the day installing the wiring harness on the TOAD.  What a   
   > job that was.  I removed interior trim and all the wiring is inside the   
   > vehicle, which I like.  Only part outside is where it goes thru the   
   > firewall to the 6 prong plug.   
   >   
   > So I tested it and the right side works fine, even hooked up to my 150.   
   > The left side not so good.  No running lights or brake lights.  It only   
   > has turn signals.  Since it doesn't work even on the Bronco alone, I'm   
   > hoping my connections are bad, or I switched something somehow.  That's   
   > enough for today.  All the wires are there now, I just gotta find the   
   > error somehow.  ARRGgghhhhh!   
   >   
   > I get why they charge so much for doing this job.  It's a doozy.   
   >   
      
   12 hours getting it all in yesterday was apparently too much.  Good   
   thing I stopped when I did.  The left side of the Bronco tail light   
   plug is upside down compared to the right side.  I had the in and out   
   sides reversed.  Even after I discovered the error, I took it apart and   
   did the same damn thing reassembling.  But once I got it wired going in   
   the right direction it all works as intended.  What a relief.   
      
   Now I just have to tidy up the wiring and get the panels all back in.   
   Install the always on 12 volt Power Plug and fuse, and silicone around   
   the grommet where I went thru the firewall.   
      
   So I thought I could do it all in a day, but I will certainly settle for   
   two.  Especially since I got more time than money.   
      
   --   
   Stand With Israel!   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)