From: kludge@panix.com   
      
   In article , Tobiah   wrote:   
   >Didn't realize batteries were low.  Machine   
   >turned off during firmware update.  Now it   
   >hangs on the splash screen during boot.  Any hope?   
      
   That's bad.  Factory repair might be able to do something... there may be a   
   way to do the firmware update either by swapping the EEPROM chip out or by   
   setting some magic jumper inside that causes it to reload the EEPROM from   
   an outside source.  But it's not going to be something that your neighborhood   
   tech can do.   
      
   Always be very careful about firmware updates on anything... don't ever do   
   it unless you have to, and if you have to always do it on AC power.   
   --scott   
      
      
   --   
   "C'est un Nagra. C'est suisse, et tres, tres precis."   
      
   --- SoupGate-DOS v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)