From: n8nagel@gmail.com   
      
   On Sunday, August 2, 2020 at 12:28:48 PM UTC-4, Steve W. wrote:   
   > Arlen Holder wrote:   
   > > On Fri, 31 Jul 2020 14:04:50 -0700 (PDT), trader_4 wrote:   
   > >   
   > >> Every pad I've installed for decades has had them, including the ones that   
   > >> use electric wear sensors.   
   > >   
   > > How many miles do you get per front pads, in general?   
   > >   
   > > As for mechanical sensors, my bimmer has only one wear sensor per axle   
   > > o No mechanical sensor; only electronic (front left and rear right).   
   > >   
   > > Although electronic is essentially mechanical, since it's a stub of plastic   
   > > that wears on contact, exposing the wires embedded inside that plastic.   
   > >   
   > > One issue is removing the sensors often breaks them if you're not careful.   
   > >   
   > > Since we rotate so frequently, checking brakes are easy; but this question   
   > > was for estimating miles for someone else who doesn't rotate as frequently   
   > > as I do (due to mountainous terrain causing specific "camber scrub" wear to   
   > > the inboard corners of the front tires).   
   > >   
   > > At the moment, with the data we have, it's about 4,000 miles per pad mm.   
   >   
   > There is no rule of thumb for brake wear because it depends more on the   
   > driver, vehicle location and the pad materials than anything else.   
   >   
   > Drive out in the plains where the only hills are long and low and the   
   > brake wear is going to be much different than if you live in the   
   > rockies. Same with driving in New York City versus San Fransisco.   
   >   
   > Another factor is the vehicle itself and how it is set up. Some will   
   > chew through brakes fast while others barely nibble. Some will go   
   > through brakes in 40K or less while others might make it to the junkyard   
   > on the OEM rears pads.   
   >   
   >   
   > The Journey we have  had all the brakes done by the dealer with OEM   
   > parts prior to our purchase, They have about 55K on them and the fronts   
   > are worn maybe 1/2 way. The rears however were just replaced, but not   
   > for wear, the rotors rusted into junk and damaged the pads. So it got   
   > new NAPA coated rotors and premium ceramics to see how they work on it,   
   > have had very good service from them on many other vehicles.   
   >   
      
   Another factor is riveted vs. bonded linings, you can run a bonded lining a   
   lot thinner than a riveted one.  5mm might be thiiiiiis close to grinding the   
   rivet heads.   
      
   nate   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)