From: curd@notformail.com   
      
   On Sun, 03 Jun 2018 16:29:02 -0700, John Larkin wrote:   
      
   > It's a nuisance to desolder caps to test them, especially surface-mount   
   > parts. It's easier to scope the circuit and look for symptoms of a bad   
   > part.   
      
   For you perhaps, but not, I suspect, the OP. Anyway, that Peak meter I   
   linked to is able to carry out in-circuit measurements, so except in   
   certain circumstances, it's not necessary to lift a lead.   
      
      
      
   --   
   This message may be freely reproduced without limit or charge only via   
   the Usenet protocol. Reproduction in whole or part through other   
   protocols, whether for profit or not, is conditional upon a charge of   
   GBP10.00 per reproduction. Publication in this manner via non-Usenet   
   protocols constitutes acceptance of this condition.   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)