From: tombiasi@optonline.net   
      
   On 9/8/2018 6:19 PM, Andy wrote:   
   > On Friday, September 7, 2018 at 2:21:38 PM UTC-5, Tom Biasi wrote:   
   >> On 9/7/2018 1:13 PM, Andy wrote:   
   >>> On Friday, September 7, 2018 at 9:15:11 AM UTC-5, jf...@my-deja.com wrote:   
   >>>> On Thursday, September 6, 2018 at 7:05:57 AM UTC-7, Andy wrote:   
   >>>>> I looked at an ampacity table but it was confusing.   
   >>>>>   
   >>>>> Would a 4 ft. length of 18 AWG wire be ok for a 10 amp load.? (Circular   
   saw)   
   >>>>>   
   >>>>> Thanks,   
   >>>>>           Andy   
   >>>>   
   >>>> This is a false economy.  You can get a 6 ft 16 gauge extension cord,   
   rated for 13A, from Lowe's for US$1.78 plus tax and interest on your credit   
   card.  My opinion is that for this small amount of money, it is not worth   
   risking your life by being a    
   cheapskate.   
   >>>   
   >>> Not being a cheapskate. Just frugal.   
   >>>   
   >> Using 18 gauge wire on a circular saw is not recommended. It should be   
   >> on a 15 amp circuit at least. That would mean 14 gauge wire if hard   
   >> wired. If you are using an extension cord I would not go smaller than 16 ga.   
   >   
   > My microwave went out. I salvaged the cord. It was at least 14 gauge.   
   >   
   > Andy   
   >   
   Are you going to make an extension cord out of it?   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)