Forums before death by AOL, social media and spammers... "We can't have nice things"
|    sci.electronics.repair    |    Fixing electronic equipment    |    124,925 messages    |
[   << oldest   |   < older   |   list   |   newer >   |   newest >>   ]
|    Message 123,364 of 124,925    |
|    sticks to sticks    |
|    Re: Will two table radios always be in p    |
|    03 Jan 23 10:04:46    |
      XPost: alt.comp.os.windows-10, alt.home.repair, sci.electronics.design       From: wolverine01@charter.net              On 1/3/2023 9:39 AM, sticks wrote:       > On 1/3/2023 8:24 AM, Arie de Muijnck wrote:       >> On 2023-01-03 11:10, Clive Arthur wrote:       >>> On 03/01/2023 02:30, Brian Gregory wrote:       >>>> On 02/01/2023 13:48, Rink wrote:       >>>>> If you change the wires of one speaker you get a 180 degree       >>>>> difference on all audio frequencies.       >>>>> If from two speakers at the some radio (left and right), one is wrong       >>>>> connected, you can hear that at exactly the middle between the       >>>>> speakers       >>>>> where there is a fase-out for all audio frequencies.       >>>>       >>>> I've never heard an audible null between out of phase speakers. It       >>>> usually just ruins the stereo effect, makes it sound almost like two       >>>> separate lots of music (or whatever).       >>>>       >>> With a mono source (ie both channels the same phase) you lose a lot       >>> of bass in the centre. Block one ear and the effect is clearer and       >>> at higher frequencies too.       >>>       >>> A long time ago, when stereo records were often mixed with the vocals       >>> in the middle and other instruments to the sides, inverting one       >>> channel and adding it to the other channel (ie subtracting it) could       >>> do a not-too-bad job of removing the vocals for karaoke.       >>>       >>       >> Yesterday I tried to check if the internal pick-off from my new TV to       >> better speaker boxes was properly wired. Hard to hear. Left/right       >> check was no problem, but phasing was hard to hear (I'm deaf, -60 dB       >> on one ear). Even with a single speaker, and a swept tone, I got dead       >> spots from wall reflections.       >> An old trick solved the problem: put the two boxes very close, front       >> to front, and test with a mono signal. Improper phasing removes most       >> of the sound, proper phasing gives full volume.       >>       >> Arie       >>       >              --- SoupGate-Win32 v1.05        * Origin: you cannot sedate... all the things you hate (1:229/2)    |
[   << oldest   |   < older   |   list   |   newer >   |   newest >>   ]
(c) 1994, bbs@darkrealms.ca