XPost: uk.d-i-y   
   From: usenet@nononono.co.uk   
      
   On 04/12/2016 10:03, Martin Brown wrote:   
   > Food processor plastic bowl seems to be polycarbonate and took a   
   > sufficiently hard thump on the hard kitchen floor to put a vertical 4cm   
   > crack in the outer case near to the handle. It will doubtless get worse   
   > if not repaired. Any suggestions for a suitable thin glue for   
   > polycarbonate that will wick into the crack and prevent it from running.   
   >   
   > Would it make sense to drill into the end of the crack for stress relief   
   > or be more likely to make it worse?   
   >   
   > Ideal glue would be food safe (so epoxy which might work isn't ideal).   
   >   
   > ISTR that petrol or ether might be good solvents for polycarbonate but I   
   > have a feeling they make it go brittle too which would be no use in a   
   > food processor where the mechanical strength is important.   
   >   
   > Any suggestions for the best glue to use here?   
   >   
   Whatever glue you use, duct tape of some variety on the outside is good   
   if there's enough 'flat' space around the crack.   
      
   Cheers   
   --   
   Syd   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)