From: treon3verdery@gmail.com   
      
   It is possible that other kinds of acoustics cause a wave overlap per unit   
   time that causes greater intensity of sensation for a given amount of motor   
   vibration; the benefit of this is that if the sensation from a particular   
   vibration form overlap is    
   twice as strong, and pleasurable to the  person using the vibrator with the   
   same amount of energy then you can use half the amount of energy and the   
   batteries last twice as long;  compare the strumming frequency of fingering to   
   orgasm, which at erotic    
   video looks like 2-3 major wiggles/second superimposed on the basic waveform   
   of the (very successful at erotic video Hitachi Magic Wand), so it the wand   
   head could strum 1-2-3 cm wide 3 times a second while also vibrating   
      
   similarly, instead of simple sinusoidal waves ~~~, other PQRS waveforms like,   
   if you were going to engineer it, find the three highest rated sexual pleasure   
   vibrators on amazon, record their waveforms, then superimpose them;  change   
   the amplitude (volume)   
    of each at a separate channel on the research test vibrators;   
      
   alternatively have a vibrator element that can handle a really wide   
   vibrational frequency range, then have a phone app that has settings for the   
   11 most highly rated sexual pleasure vibrators at amazon; make sure the   
   vibrational element can do that    
   frequency range, and verify that it is as pleasureable as the orginals; then   
   have the phone app be able to remix the top 11 vibrator frequencies to find,   
   quite possibly, even more pleasureable combined stimulations.   
      
   Since it is a phone app, the IoT bluetooth wifi sexual pleasure vibrator can   
   tell the internet at a crowdsourced site, which new frequencies are even more   
   pleasurable than the top 11 vibrators at amazon, as their functionalikes.  If   
   enough people use it,    
   then genetic algorithms and deep learning AI can make up new highly likely to   
   be even more pleasurable vibrations from a sample of just 1-10K (and the   
   sample size is likely to be much larger than that).   
      
   Bullet vibrators on alibaba are 25-29 cents, but a piezoelectric speaker with   
   two wire leads is 1 cent.   
   Subwoofers at alibaba are 50-85 cents, with a frequency range of 20Hz—200Hz;   
      
   It is better to make the new piezo-spheroidal or piezo-coated-breadstick   
   .1Hz-20k Hz vibrating element, but I do not know if Piezo can go below 100Hz.    
   sexual pleasure vibrator   
      
   So the alibaba range is 1 cent to 76 cents (Pizeo element + Bullet   
   vibrator+subwoofer); alibaba range 1-10 cents if the Spheroidal piezo element   
   and the breadstick piezoelement areeasy to make.   
       
   Notably, with a piezo element, it does not have to be flat and directional if   
   it is reengineered; a piezo ceramic coating could be produced on a spheroidal,   
   or even breadstick (long vibrations; possible vaginal insertion activity)   
   shape at a sexual    
   pleasure vibrator;    
      
   Note, the internet says of piezoelectric speakers, “little energy required   
   at low frequencies” suggesting that reengineering the piezoelectric speaker   
   to do .1-200Hz, and thus also make the .1Hz -20,000 Hz sexual pleasure   
   vibrator functional would    
   make sexual pleasure vibrators last longer per battery fill up.    
      
   Dancing solar flower magnetics: alternate magnetic windings make .1-10Hz look   
   good; The “dancing solar flowers” I have seen seem to have a 1-3 Hz   
   frequency, and a 3D autoorbital pattern of actuated motion; so, a 100 Hz and   
   up piezeoelectric combined    
   with a 1-100 Hz dancing flower winding, but stronger power could vibrate from   
   1Hz-20K Hz; also for frequencies .1-1 Hz, that could just be switching the   
   dancing flower to “thump on the side” mode anything from once every 10   
   seconds to once per second;   
      
   Another item that benefits the energy efficiency and battery life of sexual   
   pleasure vibrators is the possible use of acoustic lenses; Perhaps something   
   internal to the vibrator and possibly fresnel made out of plastic could focus   
   vibrations onto    
   superactive spots on the surface of the vibrator,    
      
   At a Wand vibrator, where the ergonomically easy to use or not-use 3/4 of the   
   way up the head has an acoustic lens at it internally; right at that spot it   
   would be like the vibrator was turned up to High, or if already on high, it   
   goes to 11 (higher),    
   but is easy to skip using if not preferred.   
      
   An alternative to a lens is the very simple idea of putting a vibrator inside   
   a vibrator; some bullet vibraotrs are about the size of the HItachi Magic   
   wand’s head, so it could be just like a regular hitachi magic wand, but with   
   the option of turning    
   on the embedded bulled vibrator in the head; aslo as a manufactured item it is   
   likely the bullet could be 1/2-1/4 its usual package size when contained at   
   the head of a wand vibrator; Also, if you run magic wand at half power, and   
   bullet vibrator at half    
   power, you get full power of vibration for sexual stimulation, but with a much   
   wider, customizable frequency range, as previously mentioned.   
      
   Some 2020 people on amazon preferred powerful but very quiet sexual pleasure   
   vibrators; GA; GA breadstick and spheroid;   
   There is an outside possibility that a VGA camera (10c), and piezospeakers   
   (1-10 cents; dollar store headphones, but more powerful) could dynamically air   
   at the users head area to do active noise cancellation; some active noise   
   cancellation is possible    
   without Cm resolution; the Bose system (RNC) for automotive vehicles makes the   
   entire car cabin quiet without aiming for the ears;  Aiming for the ears is   
   more energy effcient though, and 10 (alibaba) cents of VGA (2020) camera and   
   2-10 (alibaba) cents    
   of piezoelectric speakers, and the IC in noise cancelling headphones (25   
   cents) (or, a big IC, $.01-$1)could do it.   
      
   one person on amazon complained her vibrator “Add pressure and it loses   
   power” which suggets that an improvement to sexual pleasure vibrators is a   
   1c CPU/micorcontroller that maintains not just constant current and voltage,   
   but, sensing (at the power    
   output winding) (3 wires not 2) the kinds of things that happen to a piezo   
   element, motor/linear actuator, dancing flower or subwoofer when you hold it   
   firmly variously slight, mostly, or completely still (voltage ripple and   
   voltage non-ripple at the    
   winding); Then when you pressed it against yourself theoutput would remin high   
   and uniform.   
      
       
   One version:   
   solar flower (.1-20Hz 15c Quadrupled for stronger wire 60c, 50c 20-200 Hz   
   subwoofer, 200-20KHz piezo vibrating element, 50 c noise cancelling chip, 10   
   1c piezo antispeakers for noise cancellation,   
      
   Or the cheap way:   
      
   [continued in next message]   
      
   --- SoupGate-Win32 v1.05   
    * Origin: you cannot sedate... all the things you hate (1:229/2)